Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2008ENTOURAGE V6-3.8LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERTESTING AND INSPECTION
2008 Hyundai Entourage V6-3.8L
Keyless Entry Transmitter: Testing and Inspection
2008 Hyundai Entourage V6-3.8LSECTION Testing and Inspection
TRANSMITTER CODE REGISTRATION
1. Connect the DLC cable of scan tool to the data link connector (16 pins) in driver side crash pad lower panel, then turn the scan tool ON.
2. Select the vehicle model and then do "CODE SAVING".
3. After selecting "CODE SAVING" menu, push "ENTER" key, then the screen will be shown as below.
4. After removing the ignition key from key cylinder, push "ENTER" key to proceed to the next mode for code saving. Follow steps 1 to 4 and then code saving is completed.
1. Connect the DLC cable of scan tool to the data link connector (16 pins) in driver side crash pad lower panel, then turn the scan tool ON.
2. Select the vehicle model and then do "CODE SAVING".
3. After selecting "CODE SAVING" menu, push "ENTER" key, then the screen will be shown as below.
4. After removing the ignition key from key cylinder, push "ENTER" key to proceed to the next mode for code saving. Follow steps 1 to 4 and then code saving is completed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.