Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Hyundai Entourage GLSFACTORY OEM SERVICE PROCEDURE
Fuel System (G6DA - GSL 3.8): General: Specification: Actuators
INJECTOR
- Number: 6
- Specification
SPECIFICATION
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 11.4 ~ 12.6Ω at 20°C (68°F) |
PURGE CONTROL SOLENOID VALVE (PCSV)
- Type: Duty control type
- Specification
SPECIFICATION
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 19.0 ~ 22.0Ω at 20°C (68°F) |
VARIABLE INTAKE SOLENOID (VIS) VALVE
- Specification
SPECIFICATION
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 30.0 ~ 35.00 [22°C (71.6°F)] |
CVVT OIL CONTROL VALVE (OCV)
- Specification
SPECIFICATION
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 6.7 ~ 7.7Ω at 20°C: (68°F) |
ETC MOTOR
- Specification
SPECIFICATION
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 1.275 ~ 1.725Ω at 20t; (68°F) |
IGNITION COIL
- Type: Stick type
- Specification
SPECIFICATION
| Item | Specification |
|---|---|
| Primary Coil Resistance (Ω) | 0.62Ω ±10% at 20°C (68°F) |
| Secondary Coil Resistance (kΩ) | 7.0kΩ ±15% at 20°C (68°F) |
CANISTER CLOSE VALVE (CCV)
- Type: ON/OFF control type
- Specification
SPECIFICATION
| Item | Specification |
|---|---|
| Coil Resistance (Ω) | 19.8 ~ 21.8 at 20°C (68°F) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.