2007 Hyundai Entourage GLSFACTORY OEM SERVICE PROCEDURE

Component Inspection

  1. Check Multifunction switch
    1. Connect scantool to Data Link Connector (DLC).
    2. Ignition "ON" & engine "OFF".
    3. Check combination of wiper signal while operating front wiper switch.

      SPECIFICATION 

      SPECIFICATION

      Current DATA OFF INT LOW HIGH
      F/W HIGH OFF OFF OFF ON
      F/W LOW OFF OFF ON OFF
      F/W INT OFF ON OFF OFF
      Fig 1: Diagnosis Tool Display - Front Washer Status
      G05324924Courtesy of HYUNDAI MOTOR CO.
    4. Is the measured current data within specifications?

      YES 

      Go to " 2Check IPM" procedure.

      NO 

      Substitute with a known-good multifunction switch and check for proper operation. If the problem is corrected, replace multifunction switch and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

  2. Check IPM
    1. Connect scantool to Data Link Connector (DLC).
    2. Ignition "ON" & engine "OFF".
    3. Substitute with a known-good IPM and Check if the DTC is erased.
    4. Is the DTC erased?

      YES 

      Substitute with a known-good IPM and check for proper operation.

      If the problem is corrected, replace IPM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.