Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Hyundai Entourage GLSFACTORY OEM SERVICE PROCEDURE
Anti-Lock Braking System Control Module: Installation
- Installation is the reverse of removal.
- Tighten the HECU mounting bolts and brake tube nuts to the specified torque.
Tightening torque
HECU mounting nut :
6-10 Nm (0.6-1.0 kgf-m, 4.34-7.23 lb-ft)
HECU bracket mounting bolt:
17-26 Nm (1.7-2.6 kgf-m, 12.3-18.8 lb-ft)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.