2007 Hyundai Elantra GLS, AutomaticFACTORY OEM SERVICE PROCEDURE

Transaxle Range (Tr) Switch: Removal

  1. Remove the battery terminal.
  2. Remove the battery and battery tray.
  3. Remove the air duct.
  4. Remove the air cleaner assembly (refer to REMOVAL )
  5. Disconnect the inhibitor switch connector (A).
    Fig 1: Identifying Inhibitor Switch Connector
    G05364287
  6. Remove the control cable (A) from the manual control lever.
    Fig 2: Identifying Control Cable
    G05364288
  7. Remove the inhibitor switch and manual control lever.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.