Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Hyundai Elantra GLS, AutomaticFACTORY OEM SERVICE PROCEDURE
Solenoid Valve: Installation
- Install the solenoid valve.CAUTION: Apply the ATF oil or White Vaseline to the O-ring not to be damaged.
- Connect the solenoid valve connector to the valve body.CAUTION: When connecting the solenoid valve connector, check the connector for rust, dirt, or oil, then reconnect it.
- Install the valve body (refer to Valve Body Reassembly
in overhaul)
TORQUE:
10~12Nm (1.0~1.2kgf.m,
7~8lb-ft)
- Install the oil filter.
TORQUE :
10~12Nm (1.0~1.2kgf.m,
7~8lb-ft)
- Continue to apply liquid gasket at application points at the oil pan with 02.5mm (0.098in) thickness.
Liquid gasket Part name : Threebond 1281B
- Tighten the mounting bolt with the specified torque after installing the oil pan.
TORQUE:
10~12Nm (1.0~1.2kgf.m, 7~8lb-ft)
- Install the drain plug.
TORQUE:
35~45Nm (3.5~4.5kgf.m, 25~32lb-ft)
- Installation is the reverse of the removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
