Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Hyundai Elantra GLS, AutomaticFACTORY OEM SERVICE PROCEDURE

Shift Lever: Removal

Remove the shift lever knob (A).

Fig 1: Identifying Shift Lever Knob
Remove the center console cover (A).

Fig 2: Identifying Center Console Cover
Remove the center console, (refer to CONSOLE in BD group)

Fig 3: Identifying Center Console
Remove the control cable assembly (B) by removing the clamp (A).

Fig 4: Identifying Control Cable Assembly
Disconnect the interlock switch connector (A).

Fig 5: Identifying Interlock Switch Connector
Remove the shift lever assembly (A).

Fig 6: Identifying Shift Lever Assembly
Remove the retainer (A) and nuts (B).
NOTE: In case, remove the crush pad and cowl cross bar (refer to CRASH PAD and HEATER UNIT ).

Chapter Navigation

Return to Chapter: Shift Lever

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.