Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Hyundai Elantra GLS, AutomaticFACTORY OEM SERVICE PROCEDURE
Shift Lever: Adjustment
Adjusting method for the control cable
- Set room side lever and T/M side lever (A) to "N" position.
- Connect the room side lever and shift cable, (refer to INSTALLATION )
- Connect the T/M side lever (A) to cable (B) in this following order;
- Push the cable (B) lightly to "F" direction shown to eliminate FREE PLAY of the cable (B).
- Tighten the adjusting nut (C).
- After adjusting the cable (B) according to procedure no. 2-3, check to be sure that this part operates surely at each range of T/M side corresponding to each position of room lever.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.