2007 Hyundai Elantra GLS, AutomaticFACTORY OEM SERVICE PROCEDURE

Abs DTCS

ABS DIAGNOSTIC TROUBLE CODE DTC (LIST)

DTC CODE Trouble description Warning lamp condition Etc.
EBD ABS ESC
C1101 Battery voltage high • • •  
C1102 Battery voltage low ◦/• • •  
C1200 Wheel speed sensor front-LH open/short ◦/• • •  
C1201 Wheel speed sensor front-LH range / performance / intermittent ◦/• • •  
C1202 Wheel speed sensor front-LH invalid/no signal ◦/• • •  
C1203 Wheel speed sensor front-RH open/short ◦/◦f • •  
C1204 Wheel speed sensor front-RH range / performance / intermittent ◦/• • •  
C1205 Wheel speed sensor front-RH invalid/no signal ◦/• • •  
C1206 Wheel speed sensor rear-LH open/short ◦/◦f • •  
C1207 Wheel speed sensor rear-LH range / performance / intermittent ◦/◦f • •  
C1208 Wheel speed sensor rear-LH invalid/no signal ◦/• • •  
C1209 Wheel speed sensor rear-RH open/short ◦/• • •  
C1210 Wheel speed sensor rear-RH range / performance / intermittent ◦/◦ • •  
C1211 Wheel speed sensor rear-RH invalid/no signal ◦/• • •  
C1213 Wheel speed frequency error ◦/• • •  
C1235 Primary pressure sensor-electrical ◦ • • ESC only
C1237 Primary pressure sensor-signal ◦ • • ESC only
C1260 Steering angle sensor-signal ◦ ◦ • ESC only
C1261 Steering angle sensor not calibrated ◦ ◦ • ESC only
C1282 Yaw rate & lateral G sensor-electrical ◦ ◦ • ESC only
C1283 Yaw rate & lateral G sensor-signal ◦ ◦ • ESC only
C1503 ESC switch error ◦ ◦ • ESC only
C1513 Brake switch error ◦ • • ESC only
C1604 ECU(brake system) hardware error • • •  
C1605 CAN hardware error ◦ ◦ • ESC only
C1611 CAN time-out EMS ◦ ◦ • ESC only
C1612 CAN time-out TCM ◦ ◦ • ESC only
C1616 CAN bus off ◦ ◦ • ESC only
C1623 CAN time-out SAS ◦ ◦ • ESC only
C1625 CAN time-out ESC ◦ ◦ • ESC only
C1626 Implausible Control ◦ ◦ • ESC only
C1702 Variant Coding • • • ESC only
C2112 Valve relay error ◦/• • •  
C2308 Front-LH Valve error (Inlet valve) • • •  
C2312 Front-LH Valve error (Outlet valve) • • •  
C2316 Front-RH Valve error (Inlet valve) • • •  
C2320 Front-RH Valve error (Outlet valve) • • •  
C2324 Rear-LH Valve error (Inlet valve) • • •  
C2328 Rear-LH Valve error (Outlet valve) • • •  
C2332 Rear-RH Valve error (Inlet valve) • • •  
C2336 Rear-RH Valve error (Outlet valve) • • •  
C2366 USV1 error • • • ESC only
C2370 USV2 error • • • ESC only
C2372 HSV1 error • • • ESC only
C2374 HSV2 error • • • ESC only
C2402 Motor electrical • • •  
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.