2007 Hyundai Azera GLSFACTORY OEM SERVICE PROCEDURE

Immobilizer Control System DTCS

IMMOBILIZER CONTROL SYSTEM DIAGNOSTIC TROUBLE CODE DTC (LIST)

Immobilizer Related Faults Fault types Diagnostic codes
Transponder key fault
  1. Transponder not in password mode
  2. Transponder transport data has been changed.
 P1674
(Transponder status error)
Transponder key fault
  1. Transponder programming error
 P1675
(Transponder programming error)
SMARTRA fault
  1. Invalid message from SMARTRA to PCM(ECM)
 P1676
(SMARTRA message error)
SMARTRA fault
  1. No response from SMARTRA
  2. Antenna coil error
  3. Communication line error (Open/Short etc.)
  4. Invalid message from SMARTRA to PCM(ECM)
 P1690
(SMARTRA no response)
Antenna coil fault
  1. Antenna coil open/short circuit
 P1691
(Antenna coil error)
Immobilizer indicator lamp fault
  1. Immobilizer indicator lamp error (Cluster)
 P1692
(Immobilizer lamp error)
Transponder key fault
  1. Corrupted data from transponder
  2. More than one transponder in the magnetic field (Antenna coil)
  3. No transponder (Key without transponder) in the magnetic field (Antenna coil)
 P1693
(Transponder no response error/invalid response)
PCM(ECM) fault
  1. Request from PCM(ECM) is invalid (Protocol layer violation - Invalid request, check sum error etc.)
 P1694
(PCM(ECM) message error)
PCM(ECM) internal permanent memory (EEPROM) fault
  1. PCM(ECM) internal permanent memory (EEPROM) fault
  2. Invalid write operation to permanent memory (EEPROM)
 P1695
(PCM(ECM) memory error)
Invalid key fault
  1. Virgin transponder at PCM(ECM) status "Learnt" Learnt (Invalid) Transponder at PCM(ECM) status "Learnt" (Authentication fail)
 P1696
(Authentication fail)
Locked by timer
  1. Exceeding the maximum limit of Twice IGN ON (2 32 times)
 P1699
(Twice IG ON over trial)
Tester (SCAN TOOL) fault
  1. Request from tester is invalid (Protocol layer violation - Invalid request, check sum error etc.)
 P1697
(Tester message error)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.