Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Hyundai Azera GLSFACTORY OEM SERVICE PROCEDURE
Service Standard
ITEM STANDARD VALUE
| Items | Standard value |
|---|---|
| Brake pedal height | 184.5 mm (7.264 in) |
| Brake pedal full stroke | 128 mm (5.04 in) |
| Adjust Brake pedal full stroke | 76.2 ± 2 mm (3 ± 0.078 in) |
| Brake pedal free play | 3~8 mm (0.11 ~ 0.31 in) |
| Stop lamp switch outer case to pedal stopper clearance | 1.0 ~ 2.0 mm (0.04 ~ 0.08 in) |
| Booster push rod to master cylinder piston clearance | 0 (at 500 mmHg) |
| Parking brake pedal stroke when pedal assembly is pulled with 294 N (30 kgf, 66 lb force) | 7 Notch |
| Front disc brake pad thickness | 11 mm (0.43 in) |
| Front disc thickness | 28 mm (1.1 in) |
| Rear disc brake pad thickness | 10 mm (0.39 in) |
| Rear disc brake disc thickness | 10 mm (0.39 in) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.