Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Hyundai Azera GLSFACTORY OEM SERVICE PROCEDURE
Module Assembly Replacement
- Remove the rear door trim (See REPLACEMENT ).
- Remove the glass (See GLASS REPLACEMENT ).
- Remove the inside handle (See LATCH ASSEMBLY REPLACEMENT ).
- Remove the outside handle (See POWER WINDOW MOTOR REPLACEMENT ).
- After loosen the door module mounting bolts, remove the door module (A).
- Disconnect the connector (C).
- Detach the clips, then remove the wiring harness (A).
- Remove the module (B).
- Installation is the reverse of removal.NOTE:
- Make sure the connector is plugged in properly and each cable is connected securely.
- Make sure the door lock and open properly.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
