Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Hyundai Azera V6-3.8LFACTORY OEM SERVICE PROCEDURE
Engine Control Module: Technical Service Bulletins
- Customer Interest
- All Technical Service Bulletins
- A/T Controls - ECM/TCM Reset And Relearn Adaptive Values
- Engine Controls - ECM Replacement and Testing Procedures
- A/T, Engine Controls - ECM/TCM Reset/Relearn Procedure
- Engine, A/T Controls - Cold Start 1-2 Shift Hesitation
- Engine Controls - ECU Reprogramming Procedure
- A/T Controls - PCM/TCM Reset/Relearn Adaptive Values
- A/T Controls - Resetting PCM/TCM Adaptive Values
- Engine Controls - MIL ON/DTC's P2135/P0638
- Engine Controls - MIL ON/Multiple DTCs/Rough Idle
- A/T - MIL ON/Failsafe Mode/Multiple Solenoid DTC's Set
- Engine Controls - MIL ON/DTC P0441 Set
- A/T - Harsh/Delayed Upshift/Downshift
- A/T - Harsh/Delayed Reverse or Drive Engagement
- A/T Controls - Reset and Relearn Adaptive Values
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.