2006 Hyundai Accent AutomaticFACTORY OEM SERVICE PROCEDURE

Power Window Main Switch

  1. Disconnect the negative (-) battery terminal.
  2. Remove the front door trim panel. (Refer to the Body group - FRONT DOOR )
  3. Disconnect the 14P connector from the switch.
    Fig 1: Identifying 14P Connector From Switch
    G04803020Courtesy of HYUNDAI MOTOR CO.
  4. Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.
    Fig 2: Continuity Reference Chart
    G04803040Courtesy of HYUNDAI MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.