2005 Hyundai Tucson GLS, FWDFACTORY OEM SERVICE PROCEDURE

Shift Lever: Removal

  1. Remove the shift lever knob (A).
    Fig 1: Removing Shift Lever Knob
    G03763464Courtesy of HYUNDAI MOTOR CO.
  2. Remove the console cover (B), disconnecting the shift lever connector(A).
    Fig 2: Removing Console Cover And Disconnecting Shift Lever Connector
    G03763465Courtesy of HYUNDAI MOTOR CO.
  3. Separate the lever assembly (B) from the fascia bracket assembly(A).
    Fig 3: Separating Lever Assembly From Fascia Bracket Assembly
    G03763466Courtesy of HYUNDAI MOTOR CO.
  4. Disconnect the cable interlinked to lever assembly.
  5. In case of 4WD vehicle, disconnect the 4WD ECM connector(A).
    Fig 4: Disconnecting 4WD ECM Connector
    G03763467Courtesy of HYUNDAI MOTOR CO.
  6. Remove the fascia bracket assembly.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.