Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Hyundai Tucson GLS, FWDFACTORY OEM SERVICE PROCEDURE
Input Shaft Speed Sensor: Replacement
- Remove the battery and air cleaner (see TRANSAXLE RANGE SWITCH REPLACEMENTΒ ).
- Remove the transaxle range switch connector.
- Remove the control cable to transaxle range switch mounting nut.
- Remove the clip (A) of the control cable (B).
- Remove the control cable mounting bracket.
- Remove the input shaft speed sensor (A).
- Disconnect the input shaft speed sensor connector.
- Remove the bolt (B).
- Inspect the input shaft speed sensor bore.
- Apply a light coat of automatic transaxle fluid to the O-ring seal before installation.
- Install the input shaft speed sensor.
- Install the control cable mounting bracket.
- Connect the input shaft speed sensor connector.
- Install the holder of the control cable.
- Adjust the control cable to transaxle range switch and tighten the transaxle manual lever to the control cable mounting nut. (see INSTALLATION )
- Installation is the reverse of removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
