Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Hyundai Tiburon SEFACTORY OEM SERVICE PROCEDURE
Immobilizer Control System DTCS
IMMOBILIZER CONTROL SYSTEM DIAGNOSTIC TROUBLE CODE DTC (LIST)
| Type | Diagnostic Codes | Immobilizer Related Faults | Fault Types |
|---|---|---|---|
| SMARTRA (2.0 beta ENGINE) | P1610 | BCM fault | No answer from the BCM Invalid message from BCM to ECM |
| P1800 | Antenna error | ||
| P1803 | Invalid request from ECM or corrupted data | ||
| P1801 | Transponder fault | Invalid transponder data Passive mode invalid Programming error |
|
| P1805 | EEPROM | Inconsistent data of EEPROM Invalid write operation to EEPROM |
|
| ECM fault | No valid data from ECM after 3 attempts by ECM Invalid tester message or unexpected requests by tester |
||
| STAND ALONE (2.7 delta ENGINE) | 01 | Untaught transponder | Untaught transponder |
| 02 | Transponder communication error | Transponder error due to a wrong code or bad read (wrong transponder in field, or more than one transponder in the field). | |
| 03 | ECM communication error | ECM error due to bad Service ID (SID), Bad Message ID (MID) or protocol errors | |
| 04 | Immobilizer antenna - open | Open Immobilizer antenna | |
| 05 | BCM internal fault or EEPROM | BCM internal fault (smart driver failure) or BCM EEPROM error | |
| 06 | ECM not detected | ECM not detected |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
