2005 Hyundai Tiburon SEFACTORY OEM SERVICE PROCEDURE

Fuel Injector: Inspection

  1. Measure resistance between the terminal 1 and 2 of the injector.
    Fig 1: Measuring Resistance Between Terminal 1 And 2 Of Injector
    G03849620Courtesy of HYUNDAI MOTOR CO.
    INJECTOR RESISTANCE SPECIFICATION

    Temperature Resistance (ohm)
    (Β°C) (Β°)
    -20 -4 12.2 ~ 12.3
    0 32 13.3 ~ 13.5
    20 68 14.4 ~ 14.6
    40 104 15.5 ~ 15.7
    60 140 16.6 ~ 16.8
    80 176 17.7 ~ 17.9
    100 212 18.8 ~ 19.0
    120 248 19.9 ~ 20.1
  2. If the resistance is not within specification, replace the injector
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.