Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2005TIBURON L4-2.0LREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRREAR WHEEL ALIGNMENT
2005 Hyundai Tiburon L4-2.0L
Rear Wheel Alignment
2005 Hyundai Tiburon L4-2.0LSECTION Rear Wheel Alignment
REAR WHEEL ALIGNMENT
TOE-IN
NOTE:
^ Adjust the toe-in by fuming the tie rod end of the rear suspension arm.
^ The cam bolt should be adjusted to a maximum of 90° leg or right from the center position.
CAUTION: After adjusting the tie rod, tighten both nuts to the specified torque.
TOE-IN
NOTE:
^ Adjust the toe-in by fuming the tie rod end of the rear suspension arm.
^ The cam bolt should be adjusted to a maximum of 90° leg or right from the center position.
CAUTION: After adjusting the tie rod, tighten both nuts to the specified torque.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.