Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2005TIBURON L4-2.0LREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERTECHNICAL SERVICE BULLETINSKEYLESS ENTRY - TRANSMITTER BATTERY REPLACEMENT
2005 Hyundai Tiburon L4-2.0L
Keyless Entry - Transmitter Battery Replacement
2005 Hyundai Tiburon L4-2.0LSECTION Keyless Entry - Transmitter Battery Replacement
REMOTE TRANSMITTER BATTERY REPLACEMENT
MODEL: 2003-2005 TIBURON
DESCRIPTION:
This article describes the security system remote transmitter battery replacement procedure for the 2003- 2005 MY Tiburon.
SERVICE PROCEDURE:
1. Using a flat blade screwdriver, open and separate the remote transmitter housing.
2. Carefully remove the transmitter circuit board from its housing.
3. Using your thumb, care fully push and lift the battery against the retainer clip.
CAUTION:
Do not use tools to pry the battery from its holder.
4. Install the new battery by pushing it against the retainer clip and carefully positioning it down in the holder.
5. Install the circuit board into its housing, making sure the Lock and Unlock buttons face up.
6. Carefully snap the two halves closed.
7. Verify that the remote transmitter functions correctly.
NOTE:
See the Tiburon Shop Manual's Body Electrical System section for programming (adding) transmitter code.
WARRANTY INFORMATION
MODEL: 2003-2005 TIBURON
DESCRIPTION:
This article describes the security system remote transmitter battery replacement procedure for the 2003- 2005 MY Tiburon.
SERVICE PROCEDURE:
1. Using a flat blade screwdriver, open and separate the remote transmitter housing.
2. Carefully remove the transmitter circuit board from its housing.
3. Using your thumb, care fully push and lift the battery against the retainer clip.
CAUTION:
Do not use tools to pry the battery from its holder.
4. Install the new battery by pushing it against the retainer clip and carefully positioning it down in the holder.
5. Install the circuit board into its housing, making sure the Lock and Unlock buttons face up.
6. Carefully snap the two halves closed.
7. Verify that the remote transmitter functions correctly.
NOTE:
See the Tiburon Shop Manual's Body Electrical System section for programming (adding) transmitter code.
WARRANTY INFORMATION
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.