Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Hyundai Accent GLS, 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE
Idle Speed
NOTE:
Before adjusting, check that the spark plugs, injectors, idle speed control actuator (ISC actuator), compression etc. are normal.
- Engine coolant temperature is 80 to 95°C (176 to 205°F).
- Lights, electric cooling fan and all accessories are off.
- Transaxle is in neutral ("P" or "N" range for A/T vehicles).
- Steering wheel is in a straight forward position (Vehicles with power steering).
- Install a tachometer to the primary coil side or connect the scan tool to the data link connector.
- Start and run the engine at curb idle speed.
- Run the engine for more than 5 seconds at an engine speed of 2,000 to 3,000 RPM. Then, run the engine at idle for 2 minutes.
- Read the idling RPM.
Idle speed
SOHC: 800 +/- 100 RPM
DOHC: 800 +/- 100 RPM
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
