Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Hyundai Accent GLS, 2D Hatchback, AutomaticFACTORY OEM SERVICE PROCEDURE
Throttle Body: Inspection
- Check the throttle body for cracks.
- Check for restriction in the vacuum port or passage
- Check for interference when moving the accelerator cable.CAUTION:
- Throttle valve set screw was adjusted in the production line with the air volume (0.516 +/- 5% g/sec) during idling. So please DO NOT ADJUST IT voluntarily.
- When the idle RPM is out of specification, check the relevant sensors and their input or output value first.
- The throttle body does not need to be cleaned because carbon in throttle body does not affect the system's operation at all.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
