2004 Hyundai XG350 BaseFACTORY OEM SERVICE PROCEDURE

Trouble Shooting Hints

  1. If the engine is hard to start when hot, check for fuel pressure and injector leaks.
  2. If the injectors do not operate when the engine is cranked, then check the followings:
    • Defective power supply circuit to the PCM, faulty ground circuit
    • Defective control relay
    • Defective crankshaft position (CKP) sensor or camshaft position (CMP) sensor
  3. If there is any cylinder whose idle state remains unchanged when the fuel injectors are cut one after another during idling, check for the following items about that cylinder.
    • Injector and harness
    • Ignition plug and high tension cable
    • Compression pressure
  4. If the injection system is OK but the injector drive time is out of specification, check for the following items.
    • Poor combustion in the cylinder (faulty ignition plug, ignition coil, compression pressure, etc.)
    • Loose EGR valve seating
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.