Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Hyundai XG350 BaseFACTORY OEM SERVICE PROCEDURE
Sensor Inspection
- Disconnect the knock sensor connector.
- Measure the resistance between terminals 2 and 3.
Standard value: about 5 MΩ (at 20°C (68°F))
- If the resistance is zero, replace the knock sensor.
Knock sensor:
16~25 Nm (160~250 kg.cm, 11.8~18.4 lb.ft)
- Measure the capacitance between the terminal 2 and 3.
Standard value: 800~1600 pF
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
