2004 Hyundai Tiburon Base, StandardFACTORY OEM SERVICE PROCEDURE

Accelerator Pedal: Installation

  1. When installing the return spring and accelerator pedal, apply multi-purpose grease around each moving point (A) of the accelerator pedal.
    Fig 1: Locating Moving Points Of Accelerator Pedal
    G00893172Courtesy of HYUNDAI MOTOR CO.
  2. Apply sealant to the bolt mounting holes (A), and tighten the accelerator pedal bracket.

    Tightening torque 

    Accelerator pedal bracket bolts:

    8~12Nm (80~120 kg°Cm, 5.8~7.2 lb.ft)

    Fig 2: Applying Sealant To Accelerator Pedal Bolt Mounting Holes
    G00893173Courtesy of HYUNDAI MOTOR CO.
  3. Securely install the resin bushing of the accelerator cable on the end of the accelerator pedal.
  4. Apply multipurpose grease around the cable end (A).
Fig 3: Applying Multipurpose Grease Around Accelerator Cable End
G00893174Courtesy of HYUNDAI MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.