2004 Hyundai Tiburon Base, StandardFACTORY OEM SERVICE PROCEDURE

Fuel Pump Operation Check

  1. Turn the ignition switch OFF.
  2. Using the Hi-scan (Pro)'s actuator test mode for fuel pump, check that pump operation.
    NOTE: The fuel pump is an in-tank type and its operation is hard to hear without removing the fuel tank cap.
  3. Pinch the hose to check that fuel pressure is felt.
Fig 1: Pinching Hose To Check That Fuel Pressure Is Felt
G00893161Courtesy of HYUNDAI MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.