Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Hyundai Tiburon Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Automatic Transaxle System
- General
- Automatic Transaxle System
- Troubleshooting (A/T)
- Basic Inspection Adjustment
- Test Procedure
- Inspection Process For Diagnostic Trouble Codes
- P0707, P0708: Transaxle Range Switch (Open Circuit/Short Circuit)
- P1704, P1703, P1702: Throttle Position Sensor System
- P0712, P0713: Oil Temperature Sensor System
- P0725: Crankshaft Position Sensor System
- P0715: Input Shaft Speed Sensor System (Pulse Generator "A")
- P0720: Output Shaft Sensor System (Pulse Generator "B")
- P0703: Stop Light Switch System
- P1749: Serial Communication (Short Circuit/Open Circuit)
- P0750: Low & Reverse Solenoid Valve System, P0755: Underdrive Solenoid Valve System, P0760: Second Solenoid Valve System, P0765: Overdrive Solenoid Valve System
- P0743/P0740: Torque Converter Clutch Solenoid System
- P0731: 1st Gear Incorrect Ratio
- P0732: 2nd Gear Incorrect Ratio
- P0733: 3rd Gear Incorrect Ratio
- P0734: 4th Gear Incorrect Ratio
- P0736: Reverse Gear Incorrect Ratio
- P1630: CAN BUS Off (TCM Fail/Open/Short)
- P1631: CAN Time Out ECM (ECM Fail/Open/Short)
- P1723: A/T Control Relay System
- P1764: CAN MI-COM Circuit (TCM Internal Circuit Malfunction)
- Inspection Process For Trouble Symptoms
- Inspection Procedure 1
- Inspection Procedure 2
- Inspection Procedure 3
- Inspection Procedure 4
- Inspection Procedure 5
- Inspection Procedure 6
- Inspection Procedure 7
- Inspection Procedure 8
- Inspection Procedure 9
- Inspection Procedure 10
- Inspection Procedure 11
- Inspection Procedure 12
- Inspection Procedure 13
- Inspection Procedure 14
- Inspection Procedure 15
- Service Adjustment Procedures
- Automatic Transaxle Hydraulic Circuit
- TCM Circuit Diagram
- Automatic Transaxle
- Automatic Transaxle Shift Control
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.