Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Hyundai Tiburon Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Using MICRO 570 Analyzer
- After the battery test, press ENTER immediately for the starter test.
- After pressing ENTER key, start the engine.
- Cranking voltage and starter test results will be displayed on the screen. Take relevant action according to the test results by referring to the starter test results. See STARTER TEST RESULTS table.
STARTER TEST RESULTS
| Result On Tester Display | Remedy |
|---|---|
| Cranking Voltage Normal | System Shows A Normal Starter Draw. |
| Cranking Voltage Low | Cranking Voltage Is Lower Than Normal Level. Check Starter |
| Charge Battery | State Of Battery Charge Is Too Low To Test. Charge Battery & Retest. |
| Replace Battery | Replace Battery. Check Wiring For Open Circuit, Battery Cable Connection, Starter & Repair Or Replace As Necessary. If Engine Does Crank, Check Fuel System. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.