Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Hyundai Elantra GLS, AutomaticFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Identification
DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Definition |
|---|---|
| P0712 & P0713 | Short To Ground, Open Or Short To Battery |
| P0715 | Input Shaft Speed Sensor Open, Short To Battery Or Short To Ground |
| P0720 | Output Shaft Speed Sensor Open, Short To Battery Or Short To Ground |
| P0703 | Stop Switch Short Circuit |
| P0750 | Low & Reverse Solenoid Valve Open Or Shorted |
| P0755 | Under Drive Solenoid Valve Open Or Shorted |
| P0760 | Second (2nd) Solenoid Valve Open Or Shorted |
| P0765 | Overdrive (OD) Solenoid Valve Open Or Shorted |
| P0743 | Damper Clutch Control (DCC) Solenoid Valve Open Or Shorted |
| P0731 | 1st Gear Asynchronous Error |
| P0732 | 2nd Gear Asynchronous Error |
| P0733 | 3rd Gear Asynchronous Error |
| P0734 | 4th Gear Asynchronous Error |
| P0736 | Reverse Asynchronous Error |
| P1604 | CAN (No ID Form ECU) |
| P1603 | CAN (Communication BUS Off) |
| P0741 | Damper Clutch Abnormal System |
| P0742 | Damper Clutch Stuck On |
| P1723 | A/T Control Relay Shorted To Ground Or Open |
| P0707 & P0708 | Transaxle Range (TR) Switch Short To Ground, Open Or Shorted Between Switches |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
