2004 Hyundai Elantra GLS, AutomaticFACTORY OEM SERVICE PROCEDURE

Vehicle Speed Sensor Check

  1. Remove the vehicle speed sensor and connect a 3~10 Kohm resistance as shown in the illustration.
  2. Turn the shaft of the vehicle speed sensor and check that there is voltage between terminals 1~2 (1 turn = 4 pulses).
    Fig 1: Checking Vehicle Speed Sensor
    G00747825Courtesy of HYUNDAI MOTOR CO.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.