Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Hyundai Accent BaseFACTORY OEM SERVICE PROCEDURE
Starter Specifications
STARTER SPECIFICATIONS
| Application | Specification | ||||
|---|---|---|---|---|---|
| Armature Maximum Runout | |||||
| New | 0.001" (0.02 mm) | ||||
| In Service | 0.002" (0.05 mm) | ||||
| Brush Length | (1) | ||||
| Brush Spring Tension | |||||
| Automatic Transaxle | 3.53-3.97 Lbs. (15.7-17.7 N.) | ||||
| Manual Transaxle | 3.07-4.41 Lbs. (13.7-19.6 N.) | ||||
| Commutator Outside Diameter | |||||
| Automatic Transaxle | |||||
| New | 1.102-1.106" (28.0-28.1 mm) | ||||
| In Service | 1.083" (27.5 mm) | ||||
| Manual Transaxle | |||||
| New | 1.177-1.181" (29.9-30.0 mm) | ||||
| In Service | 1.142"(29.0 mm) | ||||
| Insulator (Mica) Depth | |||||
| Automatic Transaxle | |||||
| New | 0.016-0.020" (0.4-0.5 mm) | ||||
| In Service | 0.020-0.031" (0.5-0.8 mm) | ||||
| Manual Transaxle | |||||
| New | 0.006" (0.15 mm) | ||||
| In Service | 0.008" (0.2 mm) | ||||
| No-Load Ratings | |||||
| Maximum Draw | 60 Amps | ||||
| Minimum RPM | 5500 | ||||
| Voltage | 11.5 Volts | ||||
| Number Of Pinion Teeth | 8 | ||||
| Pinion Gap | 0.197-0.079" (0.5-2.0 mm) | ||||
| Rated Voltage | 12.0 Volts (0.9 kW) | ||||
| Type | Direct Drive | ||||
|
|||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
