Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Password Setting
Password can be used to register the master keys when you lost the ID key by using a tester (such as Hi-scan).
- INITIAL PASSWORD
The initial password for ICM has been set by the manufacturer as 2345.
Key can be registered and corrected by using the initial password until a new password is registered.
- PASSWORD REGISTRATION AND CHANGE
Using a tester (Hi-scan), the initial password (preset as 2345 all) can be replaced by a new password nominated by the owner.
4 numbers among 0-9 can be registered as password. Once the password has been changed from 2345, the ICM is ready to record the ID code.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.