Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSHYUNDAI2003XG350 LREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTMEMORY MODULESINTEGRATED MEMORY SYSTEMIMS (INTEGRATED MEMORY SYSTEM)IMS FUNCTION

2003 Hyundai XG350 L

IMS Function

2003 Hyundai XG350 LSECTION IMS Function

Memory function Prohibition condition of memory
1. After 5 sec when memory switch ON
2. Seat manual switch ON
3. Ignition switch OFF
4. Stop switch ON
5. Memory finished
  
  Fig 1: Prohibition Timing Chart
  Courtesy of HYUNDAI MOTOR CO.
Regeneration function
Prohibition condition of regeneration
1. Ignition switch OFF
2. Parking brake switch OFF and shift lever positioned except "P" position (A/T)
3. Parking brake switch OFF (M/T)
4. Vehicle speed is over 3 km/h
5. Stop switch ON
6. During the manual switch operation
Fig 2: Regeneration Timing Chart
Courtesy of HYUNDAI MOTOR CO.
ON/OFF interlock function (Seat)
Prohibition condition of interlock
1. Auto switch OFF
2. Parking brake is released (Switch OFF)
3. Stop switch ON
4. During the manual switch operation
  
  Fig 3: Seat ON/OFF Interlock Function Chart
  Courtesy of HYUNDAI MOTOR CO.
Memory or regeneration by transmitter Prohibition condition memory or regeneration by transmitter
1. Parking brake is released (Switch OFF)
2. During the manual switch operation

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.