Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2003TIBURON V6-2.7LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSBRAKES AND TRACTION CONTROLELECTRONIC BRAKE CONTROL MODULE
2003 Hyundai Tiburon V6-2.7L
Electronic Brake Control Module
2003 Hyundai Tiburon V6-2.7LSECTION Electronic Brake Control Module
GENERAL
HECU (HU + ECU)
Pump type Radial pistons (2 pistons)
Motor type 4-pole DC motor
Motor type 180W
LPA volume MCS: 3.0 cc / MOP: 3.0 cc
HPA volume 0.13 cc
Inlet valve (Front/Rear) mm (inch) 0.56 (0.022)/0.315 (0.0124)
Outlet valve (Front/Rear) mm (inch) 0.56 (0.022)/0.355 (0.0140)
TC valve relief pressure 60 - 90 bar
TIGHTENING TORQUE
Hydraulic & electronic control unit mounting bolt 8-10 Nm (80-100 kgf-cm, 6-7.4 ft. lbs.
Hydraulic & electronic control unit mounting bracket bolt 17-26 Nm (170-260 kgf-cm, 13-19 ft. lbs.)
HECU (HU + ECU)
Pump type Radial pistons (2 pistons)
Motor type 4-pole DC motor
Motor type 180W
LPA volume MCS: 3.0 cc / MOP: 3.0 cc
HPA volume 0.13 cc
Inlet valve (Front/Rear) mm (inch) 0.56 (0.022)/0.315 (0.0124)
Outlet valve (Front/Rear) mm (inch) 0.56 (0.022)/0.355 (0.0140)
TC valve relief pressure 60 - 90 bar
TIGHTENING TORQUE
Hydraulic & electronic control unit mounting bolt 8-10 Nm (80-100 kgf-cm, 6-7.4 ft. lbs.
Hydraulic & electronic control unit mounting bracket bolt 17-26 Nm (170-260 kgf-cm, 13-19 ft. lbs.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.