Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2003TIBURON V6-2.7LREPAIR AND DIAGNOSISPOWER AND GROUND DISTRIBUTIONTIMER/CONTROL UNITSERVICE AND REPAIR
2003 Hyundai Tiburon V6-2.7L
Timer/Control Unit: Service and Repair
2003 Hyundai Tiburon V6-2.7LSECTION Service and Repair
REMOVAL AND INSTALLATION
1. Disconnect the negative (-) battery terminal
2. Remove the lower crash pad panel.
3. Remove the BCM after removing the bolt and disconnect the wire connectors.
4. Installation is the reverse of removal.
1. Disconnect the negative (-) battery terminal
2. Remove the lower crash pad panel.
3. Remove the BCM after removing the bolt and disconnect the wire connectors.
4. Installation is the reverse of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.