2003 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE

Intake Manifold



INTAKE MANIFOLD 2.0L:

Factory service manual diagram





Intake manifold to cylinder head nuts and bolts.......16-23 Nm (160-230 kg-cm, 12-17 ft. lbs.)
Intake manifold stay to cylinder block bolts.......18-25 Nm (180-250 kg-cm, 13-18 ft. lbs.)
Throttle body to surge tank nuts......15-20 Nm (150-200 kg-cm, 11-14 ft. lbs.)



* Intake Manifold & Throttle Body bolt tightening sequence not supplied by manufacturer.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.