Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2003TIBURON L4-2.0LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINESYSTEM SPECIFICATIONSCRANKSHAFT
2003 Hyundai Tiburon L4-2.0L
Crankshaft
2003 Hyundai Tiburon L4-2.0LSECTION Crankshaft
CRANKSHAFT 2.0L:
Crankshaft journal O.D.: ...........57 mm (2.2440 inch)
Crankshaft pin O.D.: .............45 mm (1.7717 inch)
Crankshaft journal, pin out-of-round and taper............. 0.01 mm: (0.0004 inch) or less
Main bearing oil clearance: ..................0.028 - 0.048 mm (0.0011 - 0.0019 inch)
Connecting rod bearing oil clearance: (To set limits to new parts)......................... 0.024 - 0.044 mm (0.0009 - 0.0017 inch)
crankshaft end play
Standard value: ...............0.06 - 0.26 mm (0.0023 - 0.010 inch)
Limit: ..................0.30 mm (0.0118 inch)
Clearance between crankshaft sensor wheel and crank position sensor: ................0.5 - 1.1 mm (0.020 - 0.043 inch)
Main bearing cap bolt: ........27 - 33 Nm (270 - 330 kg.cm, 20 - 24 ft. lbs.) + (60° - 65°)
Connecting rod cap bolt: ..........50 - 53 Nm (500 - 530 kg.cm, 37 - 39 ft. lbs.)
Crankshaft end play: ..............0.06 - 0.260 mm (0.0024 - 0.0102)
Connecting rod end play: ...............0.10 - 0.25 mm (0.0039 - 0.0098 inch)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.