Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2003TIBURON L4-2.0LREPAIR AND DIAGNOSISSPECIFICATIONSELECTRICAL SPECIFICATIONSWIPER AND WASHER SYSTEMSSYSTEM SPECIFICATIONS
2003 Hyundai Tiburon L4-2.0L
System Specifications
2003 Hyundai Tiburon L4-2.0LSECTION System Specifications
Wiper motor
Rated voltage DC 12 V
Operating voltage range DC 10-15 V
Insulation resistance Min.1 MOhm
Speed/current at 1 Nm load test
Low : 44-52 rpm/3.5 A or less
Hiqh : 64-78 rpm/4.5 A or less
Speed/current at 4 Nm load test
Low : 39-47 rpm/5.5 A or less
High : 56-68 rpm/7.0 A or less
Torque/current when parking
Low 28 Nm/24 A or less
High 23 Nm/28 A or less
Windshield washer
Motor type DC ferrite magnet
Pump tvpe Centrifugal
Rated voltaqe 12 V
Discharge pressure 1.8 kg/sq.cm or more
Flow rate 1.450 cc/min. or more
Current 5.0 A or less
Overload capacity (Continuous operation)
With water 60 sec. or less
Without water (Racing) 20 sec. or less
Rear wiper motor
Speed/current at no load test 35 rpm/2.2 A or less
Speed/current at 1 Nm load test 30-40 rpm/3.5 A or less
Torque/current when parking 8 Nm/14 Aor less
Wiping angle at no load 170° ± 3°
Rated voltage DC 12 V
Operating voltage range DC 10-15 V
Insulation resistance Min.1 MOhm
Speed/current at 1 Nm load test
Low : 44-52 rpm/3.5 A or less
Hiqh : 64-78 rpm/4.5 A or less
Speed/current at 4 Nm load test
Low : 39-47 rpm/5.5 A or less
High : 56-68 rpm/7.0 A or less
Torque/current when parking
Low 28 Nm/24 A or less
High 23 Nm/28 A or less
Windshield washer
Motor type DC ferrite magnet
Pump tvpe Centrifugal
Rated voltaqe 12 V
Discharge pressure 1.8 kg/sq.cm or more
Flow rate 1.450 cc/min. or more
Current 5.0 A or less
Overload capacity (Continuous operation)
With water 60 sec. or less
Without water (Racing) 20 sec. or less
Rear wiper motor
Speed/current at no load test 35 rpm/2.2 A or less
Speed/current at 1 Nm load test 30-40 rpm/3.5 A or less
Torque/current when parking 8 Nm/14 Aor less
Wiping angle at no load 170° ± 3°
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.