2003 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE

Auto Light Control Function

AUTO LIGHT CONTROL

1. Function explanation : When multi-function lighting switch is put at AUTO position in ignition key is on state, tail lamp and headlamp turns on automatically depending on the auto light sensor values.

2. Related schematic diagrams
- See the Auto Lights.


3. Input/output signal
- Fuse : Headlamp (Low) Fuse (15 A), Headlamp (High) Fuse (15 A), F21 (10A)
- Input. Auto light switch (H14), Auto light sensor voltage (J11)
- Output: Tail lamp, headlamp

4. Related Hi-scan(pro) failure diagnosis

Factory service manual diagram



Factory service manual diagram



1. Input/output monitoring
Select "03.LAMP" and press [ENTER]. Then the following screen will be displayed.

Check BCM input/output condition against auto light switch, auto light sensor voltage, auto light option, tail lamp and headlamp.

Factory service manual diagram



Factory service manual diagram



2. Actuator inspection
Select "01 INPUT ACTUATION" and press [ENTER].

Perform forced drive against auto light switch.

5. Expected failure diagnosis
1. Auto light does not work (Tail lamp and headlamp works by the switch).
2. When auto light is turned on, tail lamp and headlamp turns on simultaneously.

NOTE: When the ambient luminous intensity is dark, tail lamp and headlamp may turn on simultaneously in auto light on condition In this case it's not the failure.

6. Actions by failure symptoms

Factory service manual diagram



1. Auto light does not work. (Tail lamp and headlamp work by the switches)

Factory service manual diagram



2. When auto light is turned on, tail lamp and headlamp turn on simultaneously.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.