Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE
Power Windows Function
POWER WINDOW
1. Input/output signal
- Fuse : F19 (30 A)
- Output: Power window output (G2)
2. Related schematic diagrams
- See the Power Windows.
3. Input/output signal
- Fuse: F19 (30 A)
- Output: Power window output (G2)


4. Related Hi-scan(pro) failure diagnosis
1. Input/output monitoring
1. Select "01.POWER" and press [ENTER] Then the following screen will be displayed.
Check BCM input condition against key state -ON or ST, key state - ON.


2. Select "07 ETC" and press [ENTER]. Then, the following screen will be displayed.
Check output condition against power window relay.


2. Actuator inspection
Select "02 OUTPUT ACTUATION" and press [ENTER].
Perform forced drive against power window power supply.
5. Expected failure symptoms
Power is not supplied to power window switch.
NOTE: As for the power window motor malfunction, refer to power window motor circuit.

6. Actions by failure symptoms
Power is not supplied to power window switch.
1. Input/output signal
- Fuse : F19 (30 A)
- Output: Power window output (G2)
2. Related schematic diagrams
- See the Power Windows.
3. Input/output signal
- Fuse: F19 (30 A)
- Output: Power window output (G2)
4. Related Hi-scan(pro) failure diagnosis
1. Input/output monitoring
1. Select "01.POWER" and press [ENTER] Then the following screen will be displayed.
Check BCM input condition against key state -ON or ST, key state - ON.
2. Select "07 ETC" and press [ENTER]. Then, the following screen will be displayed.
Check output condition against power window relay.
2. Actuator inspection
Select "02 OUTPUT ACTUATION" and press [ENTER].
Perform forced drive against power window power supply.
5. Expected failure symptoms
Power is not supplied to power window switch.
NOTE: As for the power window motor malfunction, refer to power window motor circuit.
6. Actions by failure symptoms
Power is not supplied to power window switch.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
