2003 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE

Tail Lamp Automatic Turn Off Function

TAIL LAMP AUTOMATIC TURN OFF

1. Function explanation Remove key at the tail lamp on state & Tail lamp turns off automatically when the driver's door is opened. So, Battery discharging is prevented by turning the tail lamp off.

2. Related schematic diagrams
- See the Tail, Parking & License Lamps.


3. Input/output signa
- Fuse F9 (10 A), F14 (10 A)
- Input : Driver's side door switch (E9), Tail lamp switch (H5), Door warning switch (H4)
- Output Tail lamp (C10, C11, F5, F10, J5, J15)

4. Related Hi-scan(pro) failure diagnosis

Factory service manual diagram



Factory service manual diagram



1. Input/output monitoring
1. Select "01.POWER" and press [ENTER]. Then, the following screen will be displayed.

Check BCM input condition against door warning switch.

Factory service manual diagram



Factory service manual diagram



2. Select "03.LAMP" and press [ENTER]. Then, the following screen will be displayed.
Check BCM input condition against tail lamp switch and tail lamp.

Factory service manual diagram



Factory service manual diagram



3. Select "04.DOOR" and press [ENTER]. Then, the following screen will be displayed.
Check BCM input condition against driver's side door switch.

2. Actuator inspection

Factory service manual diagram



Factory service manual diagram



1. Select "01.INPUT ACTUATION" and press [ENTER].
Perform forced drive against tail lamp switch.

Factory service manual diagram



Factory service manual diagram



2. Select "02.0UTPUT ACTUATION" and press [ENTER].
Perform forced drive against tail lamp.

5. Expected failure symptoms
1. Tail lamp does not work
2. Left tail lamp only does not work
3. Right tail lamp only does not work.
4. External tail lamp works, but internal tail lamp does not
5. Only one tail lamp does not work.
6. Tail lamp automatic turn off function does not work.

6. Actions by the failure symptoms

Factory service manual diagram



1. Tail lamp does not work.

2. Left tail lamp only does not work.
=> Fuse F(14) short check

3. Right tail lamp only does not work.
=> Fuse F(9) short check

Factory service manual diagram



4. External tail lamp works but internal tail lamp does not.

5. One tail lamp only does not work.
=> Check related wire bulb burnt

Factory service manual diagram



6. Tail lamp automatic turn off function does not work.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.