2003 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE

Outside Mirror Folding Function

OUTSIDE MIRROR FOLDING

1. Function explanation: When folding mirror switch is turned on, Mirror folds or unfolds.

2. Related schematic diagrams
- See the Power Outside Mirrors.


3. Input/output signal
- Fuse : F13 (15 A)
- Input: Folding mirror switch (E5)
- Output: Mirror folding (F20), Door unlock (F12)

Factory service manual diagram



Factory service manual diagram



4. Related Hi-scan(pro) failure diagnosis
1. Input/output monitoring
1. Select "05.LOCK & FOLDING" and press [ENTER]. Then, the following screen will be displayed.

Check BCM input/output state against folding mirror switch, outside mirror folding, outside mirror unfolding.

Factory service manual diagram



Factory service manual diagram



2. Actuator inspection
1. Select "01.INPUT ACTUATION' and then press [ENTER].
Perform forced drive against folding mirror switch.

Factory service manual diagram



Factory service manual diagram



2. Select "02.0UTPUT ACTUATION" and then press [ENTER].
Perform forced drive against outside mirror folding, outside mirror unfolding.

5. Expected failure symptoms
1. Folding function works but unfolding function does not.
2. Unfolding function works, but folding function does not.
3. Driver side mirror works, but passenger side mirror does not.
4. Passenger side mirror works, but driver side does not.
5. Both sides do not work.

Factory service manual diagram



6. Actions by the failure symptoms
1. Folding function works, but unfolding function does not.
=> Since unfolding relay is fail, replace the relay.

2. Unfolding function works, but folding function does not.
=> Since unfolding relay is fail, replace the relay.

3. Driver side mirror works but passenger side does not.

Factory service manual diagram



4. Passenger side mirror works, but driver side, does not.

Factory service manual diagram



5. Both sides do not work
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.