2003 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE

Ignition Key Hole Illumination Function

IGNITION KEY HOLE ILLUMINATION

1. Function explanation When driver's side door is opened and closed ignition key hole illumination turns on for 10 seconds so that the driver can insert the key.

2. Related schematic diagrams
- See the Immobilizer Control System.


3. Input/output signal
- Fuse F18 (10 A)
- Input Driver's side door switch (E9), Passenger's side door switch (E4)
- Output Key hole illumination (J3)

Factory service manual diagram



Factory service manual diagram



4. Related Hi-scan(pro) failure diagnosis
1. Input/output monitoring
Select "04 DOOR" and press [ENTER] Then the following screen will be displayed.

Check BCM output condition against key hole illumination.

Factory service manual diagram



Factory service manual diagram



2. Actuator inspection
Select "02.OUTPUT ACTUATION" and press [ENTER].

Perform forced drive against key hole illumination.

5. Expected failure symptoms
Key hole illumination does not work.

Factory service manual diagram



6. Actions by failure symptoms Key hole illumination does not work.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.