Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE
Fade Out Room Lamp Function
FADE OUT ROOM LAMP
1. Function explanation: It turns on when door is opened, and fades out after 5 or 6 seconds when closed.
2. Related schematic diagrams
- See the Courtesy & Luggage Room Lamp.
3. Input/output signal
- Fuse F18 (10 A)
- Input Door switch (F11)
- Output Room lamp (M3)


4. Related Hi-scan(pro) failure diagnosis
1. Input/output monitoring
Select "04. DOOR" and press [ENTER]. Then the following screen will be displayed.
Check BCM input/output condition against all door switches and room lamp.


2. Actuator inspection
Select "02 OUTPUT ACTUATION" and press [ENTER].
Perform forced drive against room lamp.
5. Expected failure symptoms.
Room lamp does not work.

6. Actions by failure symptoms Room lamp does not work.
1. Function explanation: It turns on when door is opened, and fades out after 5 or 6 seconds when closed.
2. Related schematic diagrams
- See the Courtesy & Luggage Room Lamp.
3. Input/output signal
- Fuse F18 (10 A)
- Input Door switch (F11)
- Output Room lamp (M3)
4. Related Hi-scan(pro) failure diagnosis
1. Input/output monitoring
Select "04. DOOR" and press [ENTER]. Then the following screen will be displayed.
Check BCM input/output condition against all door switches and room lamp.
2. Actuator inspection
Select "02 OUTPUT ACTUATION" and press [ENTER].
Perform forced drive against room lamp.
5. Expected failure symptoms.
Room lamp does not work.
6. Actions by failure symptoms Room lamp does not work.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
