2003 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE

Checking Steering Angle

CHECKING STEERING ANGLE


Factory service manual diagram





1. Place the front wheel on a turning radius gauge and measure the steering angle.


Wheel Angle
Inner wheel:.............................34°76' ± 2°
Outer wheel:...............................30° 19'


2. If the measured value is not within the standard value, adjust the toe and inspect again.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.