2003 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE

Power Windows Function

POWER WINDOW

1. Input/output signal
- Fuse : F19 (30 A)
- Output: Power window output (G2)

2. Related schematic diagrams
- See the Power Windows.


3. Input/output signal
- Fuse: F19 (30 A)
- Output: Power window output (G2)

Factory service manual diagram



Factory service manual diagram



4. Related Hi-scan(pro) failure diagnosis
1. Input/output monitoring
1. Select "01.POWER" and press [ENTER] Then the following screen will be displayed.

Check BCM input condition against key state -ON or ST, key state - ON.

Factory service manual diagram



Factory service manual diagram



2. Select "07 ETC" and press [ENTER]. Then, the following screen will be displayed.

Check output condition against power window relay.

Factory service manual diagram



Factory service manual diagram



2. Actuator inspection
Select "02 OUTPUT ACTUATION" and press [ENTER].
Perform forced drive against power window power supply.

5. Expected failure symptoms
Power is not supplied to power window switch.

NOTE: As for the power window motor malfunction, refer to power window motor circuit.

Factory service manual diagram



6. Actions by failure symptoms
Power is not supplied to power window switch.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.