2003 Hyundai Tiburon L4-2.0LFACTORY OEM SERVICE PROCEDURE

Flasher Function

FLASHER

1. Function explanation It works at battery(B+) state when hazard switch turns on, and works at IGN state when turn signal lamp turns on.

When the bulb burnt, hazard lamp blinks with the same interval, but turn signal lamp (left/right) blinks quickly.

2. Related schematic diagrams
- See the Turn & Hazard Lamps.


3. Input/output signal
- Fuse F07 (10 A)
- Input Hazard switch (H18), left turn signal switch (H13), right turn signal switch (H3)
- Output Left turn signal lamp (C9,17,F13) Right turn signal lamp (C5,I9,F17)

Factory service manual diagram



Factory service manual diagram



4. Related Hi-scan(pro) failure diagnosis

1. Input/output monitoring
1. Select "02 FLASH" Press [ENTER] then following screen will be displayed.

Check BCM input/output state against left turn signal lamp switch, right turn signal lamp switch, left turn signal lamp, right turn signal lamp and hazard lamp switch.

Factory service manual diagram



Factory service manual diagram



2. Actuator inspection
1. Select "01 INPUT ACTUATION and then press [ENTER].
Perform forced drive against hazard lamp switch, left turn signal lamp switch, right turn signal lamp switch.

Factory service manual diagram



Factory service manual diagram



2. Select "02 OUTPUT ACTUATION" and then press [ENTER].
Perform forced drive against left turn signal lamp, right turn signal lamp.

5. Expected failure symptoms
1. Hazard lamps do not work.
2. Right turn signal lamp does not work.
3. Left turn signal lamp does not work.
4. It blinks quickly. (When the bulb is not burnt).
5. One turn signal lamp does not work.

6. Actions by the failure symptoms

Factory service manual diagram



1. Hazard lamp does not work.

Factory service manual diagram



2. Right turn signal lamp does not work.

Factory service manual diagram



3. Right turn signal lamp does not work.

Factory service manual diagram



4. It blinks quickly (When bulb is not burnt).

Factory service manual diagram



5. One turn signal lamp does not work.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.