Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2003SANTA FE V6-3.5LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINETIMING COMPONENTSSYSTEM SPECIFICATIONS
2003 Hyundai Santa Fe V6-3.5L
System Specifications
2003 Hyundai Santa Fe V6-3.5LSECTION System Specifications
Crankshaft pulley bolt 180 - 190 Nm (1,800 - 1,900 kgf-cm, 130 - 138 ft. lbs.)
Timing belt cover bolt (M6) 10 - 12 Nm (100 - 120 kgf-cm, 7 - 9 ft. lbs.)
Timing belt cover bolt (M8) 20 - 27 Nm (200 - 270 kgf-cm, 14 - 20 ft. lbs.)
Timing belt tensioner 43 - 55 Nm (430 - 550 kgf-cm, 32 - 41 ft. lbs.)
Timing belt tensioner pulley bolt 43 - 55 Nm (430 - 550 kgf-cm, 31 - 40 ft. lbs.)
Timing belt tensioner arm FIXED BOLT 35 - 55 Nm (350 - 550 kgf-cm, 26 - 40 ft. lbs.)
Auto tensioner fixed bolt 20 - 27 Nm (200 - 270 kgf-cm, 14 - 20 ft. lbs.)
Timing belt cover bolt (M6) 10 - 12 Nm (100 - 120 kgf-cm, 7 - 9 ft. lbs.)
Timing belt cover bolt (M8) 20 - 27 Nm (200 - 270 kgf-cm, 14 - 20 ft. lbs.)
Timing belt tensioner 43 - 55 Nm (430 - 550 kgf-cm, 32 - 41 ft. lbs.)
Timing belt tensioner pulley bolt 43 - 55 Nm (430 - 550 kgf-cm, 31 - 40 ft. lbs.)
Timing belt tensioner arm FIXED BOLT 35 - 55 Nm (350 - 550 kgf-cm, 26 - 40 ft. lbs.)
Auto tensioner fixed bolt 20 - 27 Nm (200 - 270 kgf-cm, 14 - 20 ft. lbs.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.