Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2003SANTA FE BASE, AUTOMATICREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEMABS (ANTI-LOCK BRAKE SYSTEM)DIAGNOSTIC TROUBLE CODE IDENTIFICATION
2003 Hyundai Santa Fe Base, Automatic
Diagnostic Trouble Code Identification
2003 Hyundai Santa Fe Base, AutomaticSECTION Diagnostic Trouble Code Identification
DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Definition |
|---|---|
| C1101 | Voltage Out-Of-Range |
| C1102 | Voltage Out-Of-Range |
| C1200 | Wheel Speed Sensor Circuit |
| C1201 | Speed Jump Or Wrong Exciter |
| C1202 | Large Air Gap |
| C1203 | Wheel Speed Sensor Circuit |
| C1204 | Speed Jump Or Wrong Exciter |
| C1205 | Large Air Gap |
| C1206 | Wheel Speed Sensor Circuit |
| C1207 | Speed Jump Or Wrong Exciter |
| C1208 | Large Air Gap |
| C1209 | Wheel Speed Sensor Circuit |
| C1210 | Speed Jump Or Wrong Exciter |
| C1211 | Large Air Gap |
| C1274 | G-Sensor Signal Fail |
| C1275 | G-Sensor Open Or Short To Ground |
| C1604 | HECU Hardware (EEPROM & ECU Failure) |
| C1605 | CAN Hardware Error |
| C1610 | Bus Off Error |
| C1611 | CAN Timeout EMS, TCU, & Wrong Matched Transmission |
| C1612 | CAN Timeout EMS, TCU, & Wrong Matched Transmission |
| C1613 | CAN Timeout EMS, TCU, & Wrong Matched Transmission |
| C2112 | Valve Relay (Including Fuse Failure) |
| C2402 | Motor Pump Failure |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.