Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSHYUNDAI2003SANTA FE BASE, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSAUTOMATIC TRANSAXLE SYSTEM
2003 Hyundai Santa Fe Base, Automatic
Automatic Transaxle System
2003 Hyundai Santa Fe Base, AutomaticSECTION Automatic Transaxle System
- General
- Automatic Transaxle System
- Troubleshooting (A/T)
- Basic Inspection Adjustment
- Automatic Transaxle Fluid
- Transaxle Range Switch Continuity Check
- Transaxle Range Switch And Control Cable Adjustment
- A/T Control Component Check
- Test Procedure
- Inspection Process For Diagnostic Trouble Codes
- DTC P1704, P1703 & P1702: Throttle Position Sensor
- DTC P0713 & P0712: Oil Temperature Sensor System
- DTC P0725: Crankshaft Position Sensor System
- DTC P0715: Input Shaft Speed Sensor System (Pulse Generator 'A')
- DTC P0720: Output Shaft Speed Sensor System (Pulse Generator 'B')
- DTC P0703: Stop Light Switch System
- DTC P0750, P0755, P0760 & P0765: Solenoid Valve System
- DTC P0743, P0740: Torque Converter Clutch Solenoid System
- DTC P0731: 1st Gear Incorrect Ratio
- DTC P0732: 2nd Gear Incorrect Ratio
- DTC P0733: 3rd Gear Incorrect Ratio
- DTC P0734: 4th Gear Incorrect Ratio
- DTC P0736: Reverse Gear Incorrect Ratio
- DTC P1723: A/T Control Relay System
- Inspection Process For Trouble Symptoms
- Inspection Procedure 1
- Inspection Procedure 2
- Inspection Procedure 3
- Inspection Procedure 4
- Inspection Procedure 5
- Inspection Procedure 6
- Inspection Procedure 7
- Inspection Procedure 8
- Inspection Procedure 9
- Inspection Procedure 10
- Inspection Procedure 11
- Inspection Procedure 12
- Inspection Procedure 13
- Inspection Procedure 14
- Inspection Procedure 15
- Automatic Transaxle Hydraulic Circuit
- Automatic Transaxle Components
- Automatic Transaxle Shift Control Components
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.